23
Chapter 3: BIOS Setup Utility
Power Management Setup Page
This page sets some parameters for system power management operation.
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Optimized Defaults
ACPI Suspend Type
Use this item to define how your system suspends. In the default, S3 (STR), the
suspend mode is a suspend to RAM, i.e., the system shuts down with the
exception of a refresh current to the system memory.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
Power Management Setup
ACPI Suspend Type
Suspend Time Out
Resume on RTC Alarm
Resume on Ring
Resume on PME#
Resume on PS/2 Mouse
Resume on PCI-E PME
PWRON After PWR-Fail
Soft-off by PWR-BTTN
USB resume from S3
Resume from PS2 KB
Wake-up Key
Help Item
Select the ACPI
state used for
System Suspend.
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Power Off
Delay 4 Sec
Disabled
Disabled
Any Key
Parallel ATA IDE Controller
Use this item to assign IRQ to the parallel port.
OnBoard SATA-IDE
Use this item to enable the onboard SATA-IDE channel.
HDAC Audio Controller
This option allows you to control the onboard HDAC Audio. Disable this item
if you are going to install a PCI audio add-on card.
Ethernet Device
This item enables or disables the onboard Ethernet LAN.
LAN Boot ROM
Enable this item if you want to execute the Boot ROM function of onboard
LAN while starting the system.
Onboard USB Function
Enable this item if you plan to use the USB ports on this motherboard.
USB Function For DOS
Enable this item if you plan to use the USB ports on this motherboard in a DOS
environment.
S3
Use this item to assign IRQ to the parallel port.
ECP Mode DMA Channel
Parallel Port IRQ
This item assigns a DMA channel to the parallel port.
