PC-EFTPOS ANZ, Quick Reference Manual

Page: 9 / 28

HOST PHONE NO?
Enter the ANZ host phone number.
Press
[ENTER] to continue.
Allows entry of the number to dial the ANZ host. A
default number shall appear in this field. It can be
altered if required.
If the Host phone number is altered re-logon will be
required.
This prompt will not appear if comms mode of
leased line is selected.
TMS PHONE NO?
Enter the ANZ TMS phone number.
Press
[ENTER] to continue.
Allows entry of the number to dial the ANZ TMS. A
default number shall appear in this field. It can be
altered if required.
This prompt will not appear if comms mode of
leased line is selected.
LINE SPEED?
9999
Enter the Line speed for the TMS
number. Possible values are
‘1’ = 1200
‘2’ = 2400 (default)
QUICK DIAL MODE?
Enter the Quick dial mode. Press
[ENTER] to continue.
Quick Dial allows for the removal of the V52
handshaking that is associated with V22. The
removal of V52 is required when communicating
through Optus via the TPDU method.
0 = Quick Dial Off (Typically used with Telstra)
1 = Quick Dial On (Typically used with 0ptus)
This prompt will not appear if comms mode of
leased line is selected.
TMS NII?
Network International Identifier
(NII)
Enter the NII required. Press
[ENTER] to continue.
A default value of 0200 is displayed in this field.
The NCC1 previously used this value as a means of
routing messages to Prod Or Dev TMS servers. The
NII values are now 200 for Dev and Prod but
different dial numbers are used.
TMS SHA?
Enter the TMS Symbolic Host
Address. Press
[ENTER] to
continue.
Allows entry of the symbolic host address to contact
TMS. A default SHA is displayed in this field but
can be altered if required.
Configuration of Standalone Mode
1. If using the internal NPT modem, ensure Dial-up parameters are set up.
2.
Configure Standalone Mode options (Function 11112223), refer to table below.
3. Switch to Standalone Mode by pressing [Func] button then enter, followed by 11112222 then enter.
The terminal will prompt switch to standalone mode, press enter to accept.
Terminal display Comment
The merchant press [FUNC] .
FUNCTION
********
The merchant enters [1] [1] [1] [1] [2] [2] [2] [3] and press [ENTER] .
Confidential Page 9 5/23/2007