Brighten Your Digital View!
7
www.pbi-china.com
TS Bit Rate: set the bit rate of the TS comes from the TS/IP input. The setting is only
valid when the output smoothing is configured as Fixed Rate.
5.2 Outputs Menu
Under Outputs Menu, you can monitor and configure the parameters of the CI, AV decoder,
ASI out, ASI2/SDI out, Mux (A), BISS, SDI out and TS over IP output (B).
Note:
(A) The Mux menu is showed only if the built-in Mux portion is enabled. Refer to section
5.3.6.
(B) The Ethernet menu is showed only if the IP streaming in/out board is installed and the
TS/IP streaming board is set to “IP Out”. Refer to section 5.3.6.
5.2.1 BISS Menu
It includes Biss Mode, Biss 1 Setup and Biss E Setup
Biss Mode
：
Set Biss mode, can select OFF, Biss E or Biss 1
Biss 1 Setup
：
set Biss 1, password is required
Biss E Setup
：
set Biss E, ID number and password are required
5.2.2 CI Menu
There are two PCMCIA slots for inserting CAM for de-encrypting program from the input
signal.
Before setting CI, ensure the signal from ASI input is locked or the Tuner locks on the correct
Transponder (this depends on in which signal the encrypted program carried). The ‘Tuner Lock’
LED will 'on' in green.
There are 3 submenus: ‘CI Source’, ‘Setup’ and ‘CAM name’ which allow you to set or select
the parameters of the CI.
CI Source: press the <ENTER>-key, then use < > or < >-key select Tuner or ASI1 input or
ASI2 input or TS/IP input (only when the TS/IP is set “IP In”, refer section 5.2.7 for details) to
set the signal source of descrambling, press <ENTER>-key to save or press <EXIT>-key to
scrap.
Setup: under this sub menu, you can see all program names from the source of CI that was
Outputs
BISS
CI
Decoder
ASI1
ASI2
Ethernet
Mux
SDI