8
4.
Feed the backing paper through the lower opening of the exit cover. Close the
exit cover. Pull down on the backing paper to remove any slack.
When removing the backing paper, pull up across the saw -toothed tear
edge.
Make sure the backing paper tears at the edge.
5.
Close the printer's cover.
6.
Press
Feed/Cut
several times to feed at least three labels/tags to properly
position the supply and the ribbon.
A d j u s t i n g t h e W i d e / N a r r o w K n o b s
You may need to adjust the two wide/narrow knobs according to the width of your
supply. For supply that is more than two inches, adjust the knobs to the wide
setting. For supply that is two inches or less, adjust the knobs to the narrow
setting.
You must adjust both of the knobs to the same position.
If you experience ribbon smudging in cold, dry
environments, adjust the wide/narrow knobs to the
wide setting.
For wide supplies, push down and turn the
wide/narrow knobs clockwise with a screwdriver.
For narrow supplies, turn the wide/narrow knobs
counter-clockwise with a screwdriver until it pops
back up.
The adjustment is shown in the wide position.
P e el
B a r
L ow er
O p e n i n g
W i de / Na r r ow K n o b s
T e a r
E d g e
B a c ki n g
P a p er
