3
Get Started with your New Automatic Feeder
Install Batteries
1. Turn the green knob on the lid from the lock ( ) to the unlock ( ) position to release it.
2. Remove the lid and flip it upside down. You will see two separate compartments, one large
and one small.
3. Open both battery lids by pressing in the latches and pulling straight up. Fit the batteries
into their designated spaces in the compartments.
4. Close the battery compartment covers and make sure the latches snap securely into place.
5. Install the lid by fitting the protruding shaft on the feeder compartment into the
corresponding circular opening on the underside of the lid. You may have to spin the lid a
little to get the shaft to settle into place.
6. Turn the green knob on the lid from the unlock position ( ) to the lock position ( ) to
securely fasten it in place.
1&2
3
Small
Compartment
Release Knob
Large
Compartment
4
5&6
NOTE: Always use four batteries of the same brand and type. Always check batteries and battery wrappings
before installing them in the device. Do not mix used and new batteries.
