25
Fig. 29: Pulling out the filters
6. Holding it by the strap
F
, pull the heat exchanger
G
out of the
EPP housing.
Fig. 30: Removing the heat exchanger
7. Clean the heat exchanger. In doing so, proceed as follows:
•
Dip the heat exchanger several times in warm water (max. 40°C).
•
Then rinse off the heat exchanger thoroughly with warm tap water (max. 40°C).
Do not use aggressive or dissolving cleaning agents!
•
In order to dry it, position the heat exchanger such that residual water can run out of the openings.
•
Leave the heat exchanger to dry fully before reinstalling it.
Instructions on correct cleaning methods can also be found on the manufacturer's website.
8. Install the heat exchanger.
F
E
G
Summary of Contents for FOCUS 200 Base Series
