10
Proper Disassembly for Cleaning
Your Model 330A:
Always Unplug Machine From its
Electrical Source Before Cleaning
- Remove Feed Tray by lifting it off the
Hopper, and Mold Plate Guard by
loosening the Mold Plate Guard Knobs,
and unlatching the push rod.
- Remove Pressure Plate by detaching spring
and sliding Pressure Plate from inside of the
Hopper. Remove Feeder by unscrewing the
feeder bolt using speed driver provided.
Remove Feeder Washer by lifting it off the
Feeder and lift Feeder from the inside of the
Hopper.
- Remove Hopper by lifting it off the
Main Shaft of the Machine.
- Remove the four Hopper Bolts using
the speed driver provided. The two bolts
on the Chamber Lid may be removed as
well for additional cleaning.
- After the Hopper is removed from the
machine, remove Spacer Plate from the top of
the Mold Plate. *Note--Occasionally the
Spacer Plate sticks to the bottom of the
Hopper. 3/4” Molds do not use a spacer
plate.
- Remove the Mold Plate by disconnecting
the Connecting Arm from the T-Knob. This
will allow the Mold Plate to be removed from
between the Guide Rails and removed from
the machine. The T-Knob may also be un-
screwed from the Back Drive as an alternate
means of disassembly.
Feed Tray
Mold Plate
Guard
Pressure
Plate
Pressure Plate
Spring
Feeder
Chamber
Lid
Hopper
Bolts
Main Shaft
Hopper
Spacer Plate
Mold Plate
Back Drive
T-Knob
Connecting Arm
9
Push Rod
Guard
Knobs
