12
Points of Daily Lubrication For
Your Model 330A:
The Following Parts should be lubricated daily to ensure proper machine maintenance
- Pressure Foot should be lifted up
and oiled. Hold the Ball knob and
lift up. Place a few drops of oil
on the Pressure Foot shaft.
Always Unplug Machine and use Food Approved Oil and Grease!
- Knock Out Shaft should be oiled
when the Knock Out Arm is in the
up position. The picture shown
displays the Arm in the up
position.
- Tower Stem should be oiled when
the Feed Tray is removed as shown.
- Rod End Bearings should be oiled
with a few drops of oil. There are
two Rod End Bearings to be oiled. Do
not allow oil to drip onto the
Conveyor Belt.
Main Shaft
- Main Shaft should be oiled when the
machine is disassembled as shown in this
picture. Be sure to oil under the collar by the
machine cabinet.
- The inside of the machine can be oiled
through the Rear Inspection Opening. By
spraying oil here you will be oiling the inside
components.
- The Grease Fitting in the back of the machine
should be greased once every two weeks. 3 to
4 shots of grease are recommended.
Tower Stem
Pressure
Foot shaft
Knock Out Shaft
Ball Knob
Knock Out
Arm
Rod End
Bearings
Conveyor
Belt
Rear Inspection
Opening
Grease
Fitting
