Installing the SmartNode device
33
SmartNode 5550 & 4150 Series User Manual
3
• SmartNode Installation
Connecting cables
Connect the cables in the following order:
1.
Connect the ISDN terminals and NT to the BRI ports (see section
“Connecting ISDN terminals and NT
to the SmartNode device’s ISDN BRI ports”
2.
Install the RJ-11 voice port (FXS)/(FXO) cable or cables (see section
“Installing an interface cable on the
SmartNode device’s FXS and FXO interface ports”
3.
Connect the 10/100/1000Base-T Ethernet LAN and WAN (see section
1000Base-T Ethernet LAN and WAN cables”
4.
Connect the power mains cable (see section
Installation cable requirements for the WAN interface (SN5550 /2G, /4G, /AVA, /AVB /F Models)
The SmartNode SN5540 series comes with an optional Fiber-SFP, G.SHDSL(EFM-ATM) or VDSL-ADSL
WAN interface. For DSL lines use a straight-through RJ-45 cable to connect the WAN port.
For details on the G.SHDSL port pinout, refer to section
“G.SHDSL EFM & ATM port (/2G and /4G mod-
For details on the VDSL and ADSL port pinout, refer to section
“VDSL-ADSL Port (/A and /AVA & /AVB
Installation cable requirements for the SFP for Fiber WAN module (SN5550)
The SmartNode Model SN5550 comes with an option for an SFP for Fiber WAN module. For details about
the tested and compatible SFP modules see
http://www.patton.com/products/sfpmodules.asp
Connecting ISDN terminals and NT to the SmartNode device’s ISDN BRI ports
The SmartNode device comes with two or four ISDN BRI ports located on the rear panel (see
page 34). All ports can be connected to the PSTN (ISDN NT) or terminals
Do not work on the system or connect or disconnect
cables during periods of lightning activity.
The Interconnecting cables shall be acceptable for external
use and shall be rated for the proper application with
respect to voltage, current, anticipated temperature, flam-
mability, and mechanical serviceability.
WARNING
WARNING
