2. Configuring the Desired IP Address
31
SmartNode 5481 & 5491 User Manual
4
• Initial Configuration
SmartNode will provide the PC with an IP address. You can check the connection to the SmartNode by exe-
cuting the ping command from the PC command window as follows:
ping 192.168.1.1
2. Configuring the Desired IP Address
Factory-default IP Settings
The factory default configuration for the Ethernet interface IP addresses and network masks are listed in
Both Ethernet interfaces are activated upon power-up. LAN interface
ETH 0/1 (LAN)
provides a default
DHCP server, the WAN interface uses DHCP client to automatically assign the IP address and network mask.
If these addresses match with those of your network, go to section
“3. Connecting the SmartNode to the Net-
on page 32. Otherwise, refer to the following sections to change the addresses and network masks.
Login
To access the SmartNode, start the Telnet application. Type the default IP address for the SmartNode into the
address field:
192.168.1.1
. Accessing your SmartNode via a Telnet session displays the login screen. Type the
factory default login:
administrator
and leave the password empty. Press the
Enter
key after the password
prompt.
Table 7. Factory default IP address and network mask configuration
IP Address
Network Mask
WAN interface Ethernet 0 (ETH 0/0)
DHCP
DHCP
LAN interface Ethernet 1 (ETH 0/1)
192.168.1.1
255.255.255.0
DHCP address range
192.168.1.10–192.168.1.99
255.255.255.0