Patton SmartLink 4020, User Manual

Page: 78 / 97

Manual Upgrade 78
SmartLink 4020 User Manual 7 • System
Enable Auto Upgrade
Enable or disable auto upgrade—If enabled, the SmartLink 4020 will automatically check the upgrade server
on a periodic basis for new system firmware and software upon reload or power cycle.
Auto Upgrade Protocol
Select the protocol for auto upgrade
Upgrade Server
Specify the auto upgrade server IP address
Auto Upgrade URL
Specify the auto upgrade server by URL. This field is dependent on the auto upgrade service package installa-
tion. The default value is
iadmgr .
Saving your work
When you are finished configuring settings, click the
Save AutoUpgrade
button to save the changes.
Manual Upgrade
For both HTTP and TFTP methods, the device will reboot itself into the downloader mode if the main appli-
cation is executing, and proceed with the ROM file download and permanent write of the application to the
device’s flash memory. During download of new firmware images, the LEDs on the SmartLink 4020 will flash
sequentially. Typically, HTTP downloads take about 5–10 minutes. After the download is completed, the
download status page will be displayed.
Figure 52. Manual Upgrade window