Installing the router
24
SmartLink 4020 User Manual
2 • SmartLink installation
Note
The SmartLink has automatic MDX (auto-crossover) detection and configu-
ration on all Ethernet ports. Any of the ports can be connected to a host or
hub/switch with a straight-through wired cable.
Note
Follow the directions of your voice service provider to set up voice services.
Figure 3. Router front panel LEDs
Connect to the Internet service provider.
The external router power supply automatically adjusts to accept
an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to
“Contacting Patton for assistance”
on page 85 to find out how to replace it with a compatible
power cord. Plug the power adapter into the
12V DC, 1.0A
port on the SmartLink 4020. Connect the
other end of the power cord to an appropriate AC power outlet.
Wait 30 seconds after powering the SmartLink 4020 on, then verify that the green
Power
LED is lit (see
figure 3
). At this point, you should be able to use your browser to surf the Internet.
5
CAUTION
6
7
Summary of Contents for SmartLink 4020
