Application Note: Configuring the IPLink™ Router for Dual Routed Application
3
-
Remote IP address and subnet mask (of the upstream router): 192.168.1.1/24
-
No authentication
2620/KK Ethernet port parameters
The Ethernet port defines the IP subnet for WAN port 2.
•
IP parameters
-
IP address: 10.10.9.9
-
Netmask: 255.255.255.0
-
IP subnet: 10.10.9.0/24
-
Gateway route: 192.168.1.2
2620/KK WAN Port 2 configurable parameters
The second WAN port is configured as follows:
•
Channelized E1 (G.703/G.704)
-
HDB3 line coding
-
120 Ohm twisted line pair connection
-
Clocking: Not a configurable parameter. WAN port 2 derives clock from WAN 1 to synchronize the
transmitted signal on WAN port 2.
-
Time Slots: 1-31
•
WAN Service parameters
-
Bridged PPP
-
Interface 2: WAN port 2
-
No authentication
Initial Configuration
Install and configure your IPLink WAN Access Router according to the directions in the
2603 & 2620 IPLink
Quick Start Guide,
shipped with your router (and available online at www.patton.com/manuals). When cor-
rectly installed:
•
The Ethernet port will connect to the same Ethernet LAN as your PC
•
You can access the web management pages for configuration on the 2620/KK.
Access the IPLink Web Management Home Page
Access the IPlink Web Management Home page (see
figure 2
on page 5) by using a web browser on your PC.
Enter the IPLink’s IP address and log in to the IPLink.
The IPLink home page is divided into two panes, a
configuration menu pane
on the left, and a
configuration
information pane
on the right. You will use the
configuration menu pane
to navigate from page to page. You
will use the
configuration information pane
to view and modify configurable parameters, and to view IPLink
system status information.
