12
CopperLink 2300 Quick Start Guide
4.4 Change the default username
The default username will be removed once a new one is created.
Follow the command sequence below:
node~>enable
node~#configure
node~(cfg)#superuser <username> password <password>
4.5 Save the Configuration
Follow the command sequence below:
node~>enable
node~#configure
node~(cfg)#copy running-config startup-config
4.6 CopperLink LINE Commands
Local and Remote:
This will set the Ethernet Extender as Local or Remote. Local is typically used at the net-
work, Remote is typically used at the remote device or remote network. Your CopperLink 2300 when received in
a 2pk is already configured one CL2300 as Local and one CL2300 as Remote.
node(prt-line)# mode {local|remote}
Annex Type:
Please consult support before changing this setting.
node~(prt-line)[<name>]# annex-type { b-g | a-f }
Line Rate Configuration:
This will increase the line rate of the CL2300. Your CopperLink 2300 is defaulted
to automatically select the optimal rate based on the distance (adaptive).
node(prt-line)[0/0]# payload-rate {adaptive [max <192..15296>] |
<192..15296>}
Modulation Scheme:
Note higher TC-PAM rates will increase maximum payload rates available but will
decrease distance. Your CopperLink 2300 is defaulted to automatically select the optimal setting. Please consult
manual for the rate reach chart to determine your optimal setting if you choose to hard set this value. Higher TC-
PAM rates are ideal for shorter cable runs offering max symmetrical (upstream/downstream) speeds of 11.4
Mbps (TCPAM64) and 15.3 Mbps (TCPAM128) per pair.
node(prt-line)[0/0]# tcpam {auto(16/32) | auto(64/128) | 16 | 32 |
64 | 128}
CopperLink Ports:
The configurations below are used to configure various aspects of the CopperLink port(s):
node~(prt-line)# port dsl 0 0