Introduction
29
CopperLink Model 1300R Series User Manual
4 • Operation
Introduction
Once the CL1300R is properly configured and installed, it should operate transparently. The following sec-
tions describe power-up, reading the LED status monitors, and using the built-in loopback test modes.
Power-up
To apply power to the CL1300R, first be sure that you have read section
“Power input connector”
on page 15,
and that the unit is connected to the appropriate power source. Power up the unit.
LED status monitors
There are four LEDs that provide feedback on the state of the unit.
Figure 8
shows the location of the front
panel LEDs.
.
\
Figure 8. CL1314 and CL1311R front panel LEDs
Power (Green)
The Power LED glows solid during normal operation. At startup, during the POST, the LED blinks once
every second. If the POST fails, the unit does not enter normal operation, and the LED blinks once every
0.4 seconds.
Line Link (Green)
The Link LED glows solid while a link is established. While the link is training, it blinks once every second.
ETH Link (Green)
The Ethernet Link LEDs show that there is an active physical connection to the console, or an active physical
connection to an Ethernet device.
CopperLink™ Line Interface
Line Link LED
Power LED
Ethernet Port 0
Ethernet Port 1 Link LED
Ethernet Port 0 Link LED
Ethernet Port 1
Reset button
CopperLink™ Line Interface
Line Link LED
Power LED
Ethernet Port 0
Ethernet Port 0 Link LED
Reset button
Model CL1314R
Model CL1311R