Installation
26
CopperLink Model 1300R Series User Manual
3 • CopperLink installation
Connecting the Ethernet interface
This section describes how to connect the Ethernet ports to your network equipment.
The RJ-45 ports labeled Ethernet are the Auto-MDIX10/100Base-T interface. These ports are designed to
connect directly to a 10/100Base-T device or network. You may connect these ports to a hub or PC using a
straight through or crossover cable that is up to 328 ft long.
Connecting power
Figure 6. Power Supply Installation
External AC universal power supply
To connect the AC power supply, determine the positive lead and negative lead on the power adapter. Insert
the positive lead into the opening on the terminal block labeled
+
and the negative lead into the opening on the
terminal block labeled
-
. Tighten the screws on the block to secure the wires. The CL1314R powers up as soon
as it is connected to an AC power source—there is no power switch.
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
The external AC adaptor shall be a listed limited power source
that incorporates a disconnect device and shall be positioned
within easy reach of the operator. Ensure that the AC power
cable meets all applicable standards for the country in which it is
to be installed, and that it is connected to a wall outlet which has
earth ground.
CAUTION
CAUTION