Installing the SN4554
22
SN4554 Getting Started Guide
3 • SN4554 installation
Figure 6. Connecting the SN4554 to the network via a hub or switch
1.
Using the included black Ethernet cable, connect the RJ-45 Ethernet WAN port on your SN4554 (labeled
ETH), to an Ethernet hub or switch on the same network as your PC.
For details on the Ethernet port pinout and cables, refer to
Appendix C, “Cabling”
on page 45 and
Appendix
D, “Port pin-outs”
on page 48.
Connecting the SN4554 to the power supply
1.
Insert the barrel-type connector end of the AC power supply into the
5V DC, 1.0A
port (see
figure 2
on
page 15).
2.
Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to chapter 5,
“Contacting Patton for assistance”
on page 34 to find out how to replace it with a com-
patible power cord.
3.
Connect the male end of the AC power supply power cord to an appropriate AC power outlet.
The external router power supply automatically adjusts to accept
an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
Ethernet Hub
or Switch
PC
DHCP
Server
LAN
ISDN 2
ISDN 1
SN4554
ETH
port
VoIPon www.voipon.co.uk [email protected] Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
