Ethernet 10Base-T and 100Base-T
66
SmartNode 4520 & 4110 Series User Manual
C • Cabling
Ethernet 10Base-T and 100Base-T
Ethernet devices (10Base-T/100Base-T) are connected to the SmartNode over a cable with RJ-45 plugs. Use a
cross-over cable to a host, or a straight cable to a hub. See
figure 30
(host) and
figure 31
on page 67 (hub) for
the different connections.
Note
The SmartNode 4520 Series is equipped with Auto-MDX Ethernet ports.
Use straight-through wired cables for host or hub/switch connections
Figure 30. Ethernet cross-over
The Interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
Summary of Contents for SMARTNODE 4110 Series
Page 47: ...47 Chapter 5 LEDs status and monitoring Chapter contents Status LEDs 48...
Page 73: ...73 Appendix E SmartNode 4110 Series factory configuration Chapter contents Introduction 74...
Page 75: ...75 Appendix F SmartNode 4520 Series factory configuration Chapter contents Introduction 76...
Page 77: ...77 Appendix G Installation checklist Chapter contents Introduction 78...