IPLink Series High Speed Routers overview
21
Models 2603, 2621, and 2635 Getting Started Guide
1 • General Information
Console port
Located on the front panel, the unshielded RJ-45 RS-232 console DCE port (EIA-561) with the pin-out listed
in the following table:
Rear panel connectors and switches
On the rear panel from left to right are the following:
T1/E1
Link
Green
Solid green: connected
Off: disconnected
LOS
Red
On: indicates a T1/E1 loss-of-frame condition. It
also indicates that no T1/E1 signal is detected.
TD
Green
Green: indicates a binary ‘0’ condition
off
: indicates a binary ‘1’or idle condition
RD
Green
Green: indicates a binary ‘0’condition
off: indicates a binary ‘1’ or idle condition
Sync Serial
TD
Green
Green: indicates a binary ‘0’ condition
off
: indicates a binary ‘1’or idle condition
RD
Green
Green: indicates a binary ‘0’condition
off: indicates a binary ‘1’ or idle condition
CTS
Green
ON: indicates the CTS signal from the router is
active, binary ‘1’
off: indicates CTS is binary ‘0’
DTR
Green
ON: indicates the DTR signal from the DTE
device attached to the serial port is active,
binary ‘1’
Ethernet
Link
Green
ON: indicates an active 10/100 Base-T connec-
tion
100M
Green
ON: connected to a 100BaseT LAN
Off: connected to a 10BaseT LAN
Tx
Green
Flashing: when transmitting data from the router
to the Ethernet
Rx
Green
Flashing: when transmitting data from the Ether-
net to the router.
Pin No.
Signal
Direction
Signal
Name
1
Out
DSR
2
Out
CD
3
In
DTR
4
—
Signal Ground
5
Out
RD
6
In
TD
7
Out
CTS
8
In
RTS
Table 2. Status LED descriptions (Continued)
