![background image](http://html2.mh-extra.com/html/patton-electronics/4520/4520_getting-started-manual_4038151078.webp)
D • Port pin-outs
Model 4520 & 4110 Series Getting Started Guide
78
Introduction
Introduction
This section provides pin-out information for the ports of the SmartNode.
Console port
Configuration settings:
9600 bps, 8 bits, no parity, no flow control
Figure 34. EIA-561 (RJ-45 8-pin) port
Note
Pins not listed are not used.
Ethernet 10Base-T and 100Base-T port
Note
Pins not listed are not used.
FXS port
The FXS ports use an RJ-11 connector with 6 positions. The midle two positions 3 and 4 are used according
to
table 13
.
Table 12. RJ-45 socket
Pin
Signal
1
TX+
2
TX-
3
RX+
6
RX-
Table 13. RJ-11 socket
Pin
Signal
3
Ring (-)
Summary of Contents for 4520
