3 • Hardware installation
Model 4520 & 4110 Series Getting Started Guide
36
Installing the gateway router
Installing an interface cable on the router’s FXS and FXO interface ports
The gateway comes with at least two FXS or FXO analog ports—or a combination of FXS and FXO ports—(see
figure 16
) located on the back of the router. The FXS interfaces are connected to analog devices via cables (see
figure 17
) terminated with RJ-11 connectors (see
figure 19
and
table 6
on page 37 for pin-out information). The
FXO interface connects the router with analog lines via cables (see
figure 18
on page 37) terminated with RJ-11
connectors (see
figure 19
and
table 6
on page 37 for pin-out information).
Figure 16. Rear view showing location of Ethernet and FXS connectors (SmartNode 4520 shown)
Figure 17. Analog FXS connection
Summary of Contents for 4520
