![Patton electronics 4520 Getting Started Manual Download Page 38](http://html2.mh-extra.com/html/patton-electronics/4520/4520_getting-started-manual_4038151038.webp)
3 • Hardware installation
Model 4520 & 4110 Series Getting Started Guide
38
Installing the gateway router
Note
Unit must not connect directly to telecom network voltage (TNV).
Installing the Ethernet cable
The SmartNode 4520 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether-
net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable
(see
figure 20
on page 38). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode’s Ether-
net ports (see
table 7
for port pin-out listing) via a cable terminated with RJ-45 plugs. Because the SmartNode
4110 Series does not have the MDX feature, a cross-over cable is required when connecting SmartNode 4110
Series devices to a host (see
figure 21
on page 39).
Note
Pins not listed are not used.
Figure 20. Connecting a SmartNode 4110 Series device to a hub
Table 7. Ethernet 10/100Base-T (RJ-45) port pin-outs (SmartNode 4110 Series)
Pin
Signal
1
TX+
2
TX-
3
RX+
6
RX-
Summary of Contents for 4520
