EN
130
EN
131
Technical Data
Nominal voltage
230 V~ / 50 Hz
Rated power
800 W
Protection Class
I
Degree of protection
IP 20
Spindle speed
210-2500 min
-1
Chuck clamping capacity
1.5 - 16 mm
Max. drill stroke
80 mm
Base plate
410 x 240 mm
Table size
260 x 260 mm
Table bevel adjustment
+/- 45°
Net weight
46 kg
Sound pressure level (L
pA
)
< 80 dB(A)
Sound power level (L
WA
)
93 dB(A) / Uncertainty K = 3 dB(A)
Vibration emission value (a
h
)
< 2.5 m/s
2
Troubleshooting
Warning!
Make sure the tool is switched off and unplugged.
Problem
Possible cause
Solution
Motor does
not run
The gearbox lid is open
Close gearbox lid properly
The guard is not closed
Close guard
Emergency stop is pressed
Disengage emergency stop
Electrical connection is inter-
rupted.
Check mains supply
Tool does
not perform
satisfactorily
or gets stuck
Operating tool is blunt
Replace operating tool
The belts are loose
Open the motor fixing knobs, pull the
tensioning handle to the left and close the
motor fixing knobs again
The belts are worn
Contact the service center
Operating tool
turns blue
Operating tool is too hot
Use drill coolant.
Care & Maintenance
- Always keep the tool clean, dry and free of
oil or grease.
- Wear safety glasses to protect your eyes
whilst cleaning.
- For safe and proper working, always keep
the machine and ventilation slots clean.
- Regularly check to see if any dust or foreign
matter has entered the grills near the mo-
tor and around the on/off switch. Use a soft
brush to remove any accumulated dust.
- If the body of the tool needs cleaning, wipe
it with a soft damp cloth. A mild detergent
can be used but nothing like alcohol, petrol
or other cleaning agent.
- Never use caustic agents to clean plastic
parts.
- Lubricate all moving parts at regular inter-
vals.
- Periodically check all fixings. These could
become loose with time due to vibration.
Warning!
If the supply cord is dam-
aged, it must be replaced by the
manufacturer or its service agent or simi-
larly qualified person in order to avoid haz-
ard.
Warning!
Make sure the tool is
switched off and unplugged.
Noise & Vibration
The values given in these instructions have
been measured in accordance with a stand-
ardized measurement procedure specified in
EN 12717 and can be used to compare tools.
It may be used for a preliminary assessment
of exposure.
Warning!
The vibration emission
during actual use can differ from the
declared total value depending on the use
of the tool.
