PATTA AAG07-100, Operation Instructions Manual

Page: 11 / 32

- 10 -
Installing or Removing the Depressed Center Wheel
CAUTION:

Always be sure that the tool is switched
OFF and unplugged before installing or
removing the wheel.

When using a depressed center grinding
wheel, the wheel guard must be fitted
on the tool so that the closed side of the
guard always points toward the
operator.
Screw the inner flange onto the spindle.
Then fit the wheel on over the inner flange
and screw the outer flange onto the spindle. (
Fig. 5 )
Press the spindle lock firmly so that the spindle cannot revolve and then use the lock nut
wrench to tighten the outer flange securely.
To remove the wheel, follow the installation procedures in reverse.
Grinding and Sanding Operation
WARNING:
 It should never be necessary to force the tool. The weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause dangerous wheel breakage.

ALWAYS replace wheel if tool is dropped while grinding.

NEVER bang or hit grinding disc or wheel onto work.
 Avoid bouncing and snagging the wheel, especially when working corners, sharp edges etc.
This can cause loss of control and kickback.

NEVER use tool with wood cutting blades and other sawblades. Such blades when used on a
grinder frequently kick and cause loss of control leading to personal injury.