Page
5
of 16 HPS 848 R.2
User section
SPECIAL PROTECTION FUNCTION
The IMMOBILIZER functions, ANTI-AGGRESSION and ANTI-THEFT
ARE NOT ACTIVE
in the default configuration. Their activation can
be done exclusively on the customer's request and only by qualified
personnel. Warning this function are managed by the P
rogramming
Pushbutton (that must be installed) or
by the transponder
device (
HPA977
)
Button RESET - HPA 977
IMMOBILIZER FUNCTION (N° 27)
This function, if programmed, is activated when you switched off the alarm.
From this moment and within 30 sec. the function must be reset by the presence of the
transponder or the appropriately installed RESET button. If not, a full alarm cycle with starts with
engine block. The ignition ON skips the timeout and trigs a direct alarm cycle with engine block.
Also, the opening of any doors after 15 sec. starts a direct alarm cycle.
If the function is started you can re-arm the system by remote control or with vehicle self locking.
CAUTION: disarming the alarm (unlocking with original remote control) out of the range
of the transponder, after 30 seconds trigs an audible and visual alarm cycle.
ANTI-AGGRESSION FUNCTION (N°
10)
-
Can bus vehicle.
The vehicle speed, after the ignition key turn ON, controls the
activation and the engine block of the ANTIAGGRESSION function. The alarm system will request
the Transponder recognition after passing the 10km/h speed threshold and, if the system cannot
detect the recognition, after 40 seconds, the alarm system actives the siren sound for 20 seconds
(pre-alarm), form now if the vehicle speed falls below the 10 km/h speed threshold (settable), the
engine block will be activated.
-
No Can bus vehicle.
Turn ON the key, the procedure start, the LED start to flash. After
40 seconds, the alarm system actives the siren sound for 20 seconds (pre-alarm), after that it will
stop the engine by the intermittent activation within 50 seconds.
The ANTIAGGRESSION procedure can be stopped every time by the anti theft push button or by the
HPA 977 Transponder signal recognition.
ANTI
–
THEFT FUNCTION (N° 11)
-
Can bus vehicle.
The vehicle speed, after the driver door open and close, controls the
activation and the engine block of the ANTIAGGRESSION function. The alarm system will request
the Transponder recognition after passing the 10km/h speed threshold and, if the system cannot
detect the recognition, after 40 seconds, the alarm system actives the siren sound for 20 seconds
(pre-alarm), form now if the vehicle speed falls below the 10 km/h speed threshold (settable), the
engine block will be activated.
-
No Can bus vehicle.
Engine is ON, open and close the door checked, the procedure
start, the LED start to flash. After 40 seconds, the alarm system actives the siren sound for 20
seconds (pre-alarm), after that it will stop the engine by the intermittent activation within 50
seconds.
The ANTI THEFT procedure can be stopped every time by the anti theft push button or by the HPA
977 Transponder signal recognition.
