EN
12
Operation with detergent
Detergent can only be added when the device is operated in low pressure mode.
DANGER
When using detergents, the material data safety sheet issued by the detergent manufacturer
must be adhered, especially the instructions regarding personal protective equipment.
Remove the cap of the clean detergent bottle. Gently pull the onboard detergent tank out of
its storage position.
Fill the tank with detergent designed specifically for use with pressure washers.
Push the detergent bottle with the opening pointing downwards into the connection for the
hose clean detergent.
Recommended cleaning method
•
Spray the detergent sparingly on the dry surface and allow it to react, but not to dry.
•
Spray off loosened dirt with the high pressure Met.
After operation with detergent
•
Remove the hose clean detergent bottle from the intake and close it with the lid.
•
For storage, put the detergent bottle into the retainer with the cap pointing up.
Interrupting operation
•
Release the lever of the trigger gun.
•
Lock the lever of the trigger gun.
•
Put the trigger gun with the spray lance into the parking position.
•
During longer breaks(more than 5 minutes), also turn the appliance off using the
“OFF/ON” switch.
Finish
operation
•
Release the lever of the trigger gun.
•
Turn off the appliance " OFF/ON”.
•
Disconnect the mains plug from the socket.
Only separate the high
-
pressure hose from the trigger gun or the device when there is no
pressure in the system.
TURN OFF TAP
•
Pressure the lever of the trigger gun to release any remaining pressure in the system.
•
Release the lever of the trigger gun.
•
Lock the lever of the trigger gun.
ATTENTION
•
When disconnecting the supply or high pressure hose, warm water may leak from the
conn
ection after operation.
•
Detach the appliance from the water supply.
