The machine is not intended to be connected to the potable water mains. If you want to connect
the machine to the potable water mains, you must use a backflow prevention device type BA, in
accordance with EN 12729.
Connect the machine to the power supplies.
STARTING-UP
•
Open the water inlet. Press the safety pin on the spray handle and pull back trigger lever in
order to bleed the trapped air out of the device.
•
Turn on the switch ON/OFF on the device (Fig.8).
•
To temporari
ly turn off, release the trigger lever, at which point the device goes to standby. As
soon as you press the trigger lever again, the high pressure cleaner restarts (Total Stop device).
CAUTION:
the motor continues running for a few seconds after letting go of the gun trigger.
Wait for the motor to stop completely before pressing the trigger again. Do not let go and
press it immediately.
•
To completely turn off the high pressure cleaner, press the ON/OFF switch on the device.
•
The shape of the water jet can be
changed from concentrated to flat jet by turning the head
-
nozzle.
•
Using the lance with rotating nozzle is particularly effective in cases of very stubborn dirt.
CORRECT USING THE DEVICE
1.
The high pressure cleaner must be set upright on a level, stable surface. according Fig.2.
2.
The spray lance is affected by a thrust during operation
– therefore, always hold it firmly with
both hands.
IMPORTANT: Point the nozzle at the ground.
3.
Activate the trigger of the spray handle.
4.
Always adjust the distance and thus the pressure of the nozzle to the surface which is to be
cleaned.
NOTE:
The spray angle can be adjusted at the nozzle. (Fig.9).
NOTE:
Do not cover the machine during operation. If the machine
is left or not used; it must be
switched off on the start. Stop switch (press the ON/OFF switch immediately).
It is normal for the pump to leak a little; this is necessary to avoid damage to the pump when it is at a
standstill.
END OF OPERATION
1.
Shut off the water supply and drain the water under pressure remaining in the machine, operate
it for a few seconds with the lever spray handle pressed.
2.
Press the ON/OFF switch.
3.
Disconnect the plug from the socket.
MAINTENANCE
WARNING!
Always disconnect the plug form the socket prior to maintenance or cleaning.
To ensure a long and problem free working life, please take the following advice:
•
wash off water hose, high pressure hose, spray lance and accessories before mounting;
•
clean the connectors of dust and sand;
•
rinse the detergent praying attachment after use.
Any repair should always be made in an authorized workshop with original spare parts.
10
