•
The water jet that emerges from the high pressure nozzle produces a ‘kickback’ on the spray
handle. Therefore, make sure that you have a solid footing and that you have a firm hold of the
handle grip. In order to protect yourself from possible flying objects (that are released due to
the high pressure).
•
The high pressure jet can damage vehicle tires and tire parts. Keep a distance of at least 30 cm
from the object being cleaned.
•
If ther
e is a power failure while you are using the machine, be sure to switch off the machine for
safety reasons.
•
The electric pump always must be able to draw on a sufficient supply of water. Dry operation
causes severe damage to the seals.
•
Disconnect from the
power supply before carrying out user maintenance.
•
Only use original spare parts from the Manufacturer or approved by the Manufacturer.
•
If the supply cord is damaged, it must be replaced by the Manufacturer, its service agent or
similar qualified persons in order to avoid a hazard.
•
Never use the machine in an environment where there could be a danger of explosion. If any
doubt arises, please contact the local authorities.
•
It is not allowed to clean asbestos
-containing surfaces with high pressure.
•
This high pressure washer must not
be used at temperatures below 0
°C.
PRIOR TO OPERATION
Before starting up the machine please check it carefully for any defects. If you find any, do not start
up the machine and contact your distributor.
Especially check
The
insulation of the electric cable should be faultless and without any cracks. If the electric cable is
damaged, it should be replaced by an authorized distributor.
MAINS POWER SUPPLY CONNECTION
The following should be observed when connecting the high press
ure cleaner to the electric
installation:
•
check before operation that the local power supply is the same as the specifications on the
rating label;
•
this machine is equipped with an universal motor with double insulation
: it is not necessary
to have earth
connection;
•
the electric installation shall be made by a certified electrician;
•
it is strongly recommended that the power supply to the machine should include a residual
current device (GFCI);
•
product protection degree: IPX5.
SAFETY DEVICES
Locking device on spray handle.
The spray handle features a locking device. When the lock is activated, the spray handle cannot be
operated.
Motor pump protection
The motor is equipped with a motor circuit breaker switch. When the motor starts to run hot, it is cut
out
by this switch. Switch off the machine. Wait 5
-
10 minutes before using the device again. Try to
determine the cause of the fault. If the problem repeats itself, please contact a customer service
center.
8
