10
7
Reflector Assembly
1. Fasten 5- Hub Angles to Hub as shown, using 3- 3/8x1 bolt hardware from Hub to Angle
Hardware Pack. (2- 3/8” washer, 1-nut per)
2. Adjust the Hub into the position shown, and select the shortest Radial Beam assembly - “C”
and place into the outermost location inside the Hub. Fasten using 3/8in shoulder bolt from
Radial Beam to Angle Hardware Pack. (1 - 3/8” washer,1- 5/16 lock washer & 1-nut per) Leave
1/2 turn loose.
Do the same with the opposing “C” Radial Beam assembly.
NOTE: Hard to reach hardware can be accessed by reaching inside and around the end of the
Radial Beam to reach the back side.
3. Repeat step 2 for “B”, and “A” Radial Beam assemblies.
4. Tighten all Radial Beam hardware in steps 1 through 3.
C
C
B
B
A
RADIAL BEAM
ASSEMBLY C
HUB ASSEMBY
HUB ANGLE
Important:
Make sure Radial Beams are attached to the
INSIDE of the hub angle to insure proper
beam focus, using one 3/8 washer, one 5/16
lock washer, and one 5/16 nut per
3/8 shoulder bolt.
!
4M45004
224115
224109
224109
224106
224106
22410
Summary of Contents for 2.4m Offset Antenna
Page 1: ...2 4m Offset Antenna Receive only and Transmit Receive...
Page 19: ......
