8
Lens Cover
Light Kit
Blade Arm
Slot
Motor Screw
Fitter Plate Screw
Light Kit
Fitter Plate
Single-pin
Connector
ASSEMBLY INSTRUCTIONS
14. To install the light kit, connect the single-pin
connectors from the motor assembly to the single-pin
connectors from the light kit -- Blue to Black and White to
White. Reinsert two of the previously removed fitter plate
screws into the fitter plate, but do not tighten. Place the
keyholes of the light kit over the fitter plate screws and
turn clockwise. Secure the light kit with the third fitter
plate screw. Tighten all three fitter plate screws.
15. Lift the lens cover over the light kit and turn clockwise
until its secure.
CAUTION:
Avoid cross-threading the lens cover during
installation. Improper installation could cause the lens
cover to be difficult to remove or fall, which could cause
serious injury.
14
15
13. Slide the end of the blade arm through one of the slots
in the side of the motor assembly. Then, use the motor
screws to secure the blade arms to the underside of the
motor assembly. Securely tighten each blade arm before
moving to the next.
13
Battery
Door
Battery
Battery
Compartment
16
16. Remove the battery cover from the back of the remote
transmitter and insert the 12-volt battery, noting polarity
-- positive (+) to positive (+) and negative (-) to negative
(-). Replace the battery cover. If battery is installed
correctly, the LED indicator on the front of the remote
transmitter should illuminate when any button is pushed.
