7
Black (hot/power)
White (neutral)
Bare/Green
(ground)
Red
Whit
e
White
Whit
e
Blac
k
Blue
Blue
Black
Green
Gree
n
Receive
r
Canopy
Round
Hole
Mounting Bracket Screw
J-Shaped Slot
ASSEMBLY INSTRUCTIONS
11. Raise the canopy, ensure the two mounting bracket
screws are aligned with the J-shaped slots in the canopy.
Then turn the canopy clockwise until the mounting
bracket screws are completely engaged in the J-shaped
slots. Install the two previously removed mounting
bracket screws in the round holes. Securely tighten all four
mounting bracket screws.
Wire Connector
10
Mounting
Bracket
9
11
10. Use wire connectors to connect power supply wires to
the receiver and the fan according to the wiring diagram and
the following instructions:
• Connect the green wires from the downrod and mounting
bracket to the bare/green (ground) supply wire.
• Connect the Blue wire (FOR LIGHT) from the receiver to the
Blue fan wire.
• Connect the Black wire (TO MOTOR L) from the receiver to
the Black fan wire.
• Connect the White wire (TO MOTOR N) from the receiver to
the White fan wire.
• Connect the Red wire (AC IN L) from the receiver to the Black
(hot/power) supply wire.
• Connect the White (AC IN N) from the receiver to the White
(neutral) supply wire.
Important:
After the connections have been made, the
connected wires should be turned upward and pushed
carefully up into the outlet box. Place the black and white
wire connections on opposite sides of the outlet box.
Receiver
9. Insert the receiver in the mounting bracket with
antenna end first and flat side facing up.
Note:
The receiver rests directly on the downrod.
Blade Screw
Screw Cap
Blade Arm
Blade
12
12. Partially insert three blade screws through the blade
arm and the blade. Secure each blade screw with a blade
screw cap, starting with the one in the middle. Repeat this
step for the remaining blades and blade arms.
