ASSEMBLY INSTRUCTIONS
CAUTION:
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and diagram. If any part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated assembly time: 5 min.
• NOTE: This fixture is only compatible with fixture models: 29145 & 29146.
• Maximum number of fixtures per run can not exceed 10 of the 27 inch fixtures (model 29146) or
the combined fixture wattage of 100W.
1.
Keep in mind the distance from fixture (B) to
receptacle and the power cord (A) length. Mounting
surface should be a minimum of 1/2 in. thick. When
installing multiple fixtures in a run, leave a minimum of
2-1/2 in. clearance for interconnection cord between
fixtures.
The power cord (A) only plugs into one end of each
fixture (B). Make sure the 120 volt input end of the
fixture is loacted where the power cord will reach it.
The interconnection cord will plug into either end of
the fixture.
2.
Hold fixture housing (B) in desired position and mark
position of mounting holes.
Attch fixture(s) (B) to surface with screws (BB). If
needed, drill a 1/16 in. pilot hole.
4
1
A
B
2
B
BB
Hardware Used
Machine
Screws
BB
x 2
