18 | P a g e
PATON
®
ADI 200 STANDARD TIG/MMA MIG/MAG
4.2 ARGON ARC WELDING PROCESS WITH TIG-2T FUNCTION
4.2.1 PREPARING THE WELDING UNIT FOR OPERATION
Preparation the welding unit for TIG 2T operation:
1.
Connect the
TIG
torch to connector socket
B (-).
2.
Connect the grounding cable to connector socket
A (+).
3.
Connect the gas hose of the
TIG
torch to the socket
(8)
(on the left side)
4.
Connect the
TIG
torch control cable to the control connector
(7)
(on the right side)
5.
Connect the grounding cable to the workpiece.
6.
Connect the pressure reducer to the fitting of the cylinder with protective gas.
7.
Connect the hose from pressure reducer of the gas cylinder to fitting
(10)
on the rear panel
of the welding unit.
8.
Open the shut-off valve of the gas cylinder. Check the tightness of the connection with the
gas cylinder.
9.
Connect the power cable of the welding unit to the outlet of the power supply system.
10.
Set switch
(9)
on the rear panel of the welding unit to position I (switching on).
11.
Switch the button
(4)
to the
TIG
welding position, if the desired welding method has been
skipped, press the button
(4)
again - the methods are switched over and over again
12.
Holding the button
(3)
for about 5 seconds, we gain access to the locked functions of the
device;
13.
Press button
(3)
and hold it until
[BUTTON MODE]
indication is displayed for selecting
the
TIG-2T
contactless arc starting function of the button on the welding torch. When
button
(3)
is released, after 1 s, the display will show the value of the current function. Set
value
[2T]
by buttons
(1)
. If the
TIG-2T
contactless arc starting function has been missed
during the selection, press and hold button
(3)
again for sequentially selecting the function
required.
14.
Using the buttons
(1)
set the current basic parameter - welding current or parameter of the
selected function;
15.
The device is ready for use.
Enjoy Your work.
If required, perform the additional functions specified for the argon arc welding process (see Section
6.1).
WORKPIECE
ARGON
ARGON
WELDING
TORCH
GROUNDING CLAMP
~230V
