60
Pole
Pole Waterproof
Ring
Circular Bracket
Binding Head Tapping Screw
3×12
2 pcs.
0.8 N m
Recommended Torque
Waterproof Packing
（
Secure with double-sided tape
）
Enlarged Drawing
1. Install the Pole Waterproof Ring in the Circular Bracket.
Check that the 2 ribs are on the outside.
2. Insert Pole into the Circular Bracket. See the figure on the left for
details on the direction of insertion.
3. Tighten the Binding Head Tapping Screws (2 pcs.) from
underneath the Circular Bracket.
4. Put the Waterproof Packing on the bottom of Circular Bracket.
Take a cable out from a side
（
Processing Method
）
This part has perforations to make it possible to run a cable out from the side.
1.
Refer to the enlarged drawing and cut the outlined
part of the bracket.
Cut in two places with nippers.
2.
Break off the outlined part with pliers. If there are
burrs, carefully remove with plyers or a file.
Installation using materials other than the specified
accessories is not covered under warranty.
N o t i c e
Pole Installation
Cutting a side-hole for cable (Procedure)
ghv Vertriebs-GmbH
| Am Schammacher Feld 47 | 85567 Grafing | T 49 80 92 81 89 0 | [email protected] |
www.ghv.de
