Paso PAW3500-VES, Instructions For Use Manual

Page: 73 / 84

33 System manual PAW3500-VES Compact systems
IT
PAW3500-VES
Label Application See panel Notes
Control input Controlled Input contacts
Panel for con fi guring the controlled
inputs.
To go from one input to another
(from 1 to 7), press
Next or Prev .
Press Mode to select one of the
following modes:
-
Message input > Edit zone
Setting of the messages for the
zones (E = evac, A = alert,
N = none)
-
Not active input
- Reset input
Press Control to enable or disable
control over the concerned input.
Press Logic to set the logic
typology attributed to the
concerned input, choosing
between:
-
Positive (active high)
- Negative (active low)
To leave the screen, press
‘
Escape ’.
Output Relay output
Panel for con fi guring the relay
output.
Activate or de-activate (On/Off) the
type of event to be associated with
the output in question by pressing
the appropriate buttons.
To leave the screen, press
‘
Escape ’.
Charger Battery charger
Battery con fi guration panel.
By pressing ‘ Change ’ it is possible
to set:
- The capacity of the battery
(choose between 18, 26, 33
or 40 Ah).
- ‘ Energy save ’ mode enabled
disabled. This enables the
batteries to remain in the
energy saving mode when
there is no mains power.
2 AMP (Pmax = 250W)
Capacity Duration without mains supply
18 Ah
24 h + 30 min*
26 Ah 35 h + 30 min
33 Ah 44 h + 30 min
40 Ah 72 h + 30 min
* According to UNI ISO 7240-19
point 5.15.3 requirements:
24 h standby plus 30 minutes in vocal
alarm condition.