6
Successive (Bounce) Driving
■
Grasp the handle firmly.
■
Squeeze the trigger and move the tool along the work-
piece with a bouncing motion, depressing the work con-
tacting element at the points where you want to insert a
fastener.
■
Keep the trigger depressed and continue to bounce the
work contacing element against the workpiece, positioning
the tool above as carefully as possible.
■
When the desired number of fasteners have been driven,
release the tool trigger to avoid unintentional fastener dis-
charge.
Sequential Operation - (Gray Trigger)
The sequential operating kit prevents successive or
“bounce” driving.
■
Depress the work contacting element and hold it against
the work surface before pulling the trigger.
■
After each fastener is driven, completely release the trig-
ger and lift the tool from the work surface.
TOOL OPERATION -
continued
Use only fasteners that meet Paslode specifications.
Use of fasteners that do not meet Paslode specifica-
tions can result in damage to the tool or injury to the
operator or bystanders.
WARNING
®
®
Precision Placement Driving
(Orange Trigger)
■
Grasp the tool handle firmly and hold the bottom of the
work contacting element firmly against the workpiece until
it is completely depressed.
■
Squeeze the trigger to drive the fastener.
■
Lift the tool from the workpiece.
■
Repeat the procedure for the next fastener.
Driving of Nails
■
A
B
C
CHANGING THE TRIGGER
1. Disconnect the tool from air source.
2. Remove trigger step pin rubber retaining ring (
A
).
3. Remove trigger step pin (
B
).
4. Remove sequential trigger assembly
C
(Gray, part # 576918) and spring.
5. Install contact trigger
D
(part# 576917,
Orange)
with spring and align hole and reinsert Trigger
step pin.
6. Reinstall rubber retaining ring and
check for correct operation.
D
Adjust the Depth of Drive
(Orange Trigger)
