www.parweld.com
12
7.7 TIG Welding
Follow the screen prompts to complete the machine set up.
7.7.1 TIG Torch Selection
Select the HELP menu from the main Process Selection screen and
follow the screen prompts as follows.
Adjust Amperage Value
Adjust Arcforce Value
7.6 MMA Welding
Follow the screen prompts to complete the machine setup.
Example setting.
7.5 MIG Welding Procedure
1. Position wire over joint. The end of the wire may be lightly
touching the work.
2. Lower welding helmet, operate torch trigger, and begin welding.
Hold the torch so the contact tip to work distance is about 3/8”
(10 mm).
3. To stop welding, release the torch trigger and then pull the torch
away from the work after the arc goes out.
4. When no more welding is to be done, close valve on gas cylinder
(if used), momentarily operate torch trigger to release gas
pressure and turn off the machine.
Summary of Contents for XTM 211Di
Page 1: ...OPERATOR MANUAL ISSUE 1 XTM 211Di ...
Page 27: ...www parweld com 27 ...
