Particle Monitor One, Manual

Page: 6 / 45

Mounting
The Monitor One is intended to be mounted in the orientation shown at the top of the page, with
the connectors facing down. You can also mount it with the mounting plate mounted on a flat
surface as the GNSS antenna is angled to allow it to work in either orientation.
When using external cellular and GNSS antennas you can orient the Monitor One in other
directions.
Label Details
1 Mounting screw or bolt holes
2 Slots for strap mounting
3 Magnets
4 Mounting plate removal screw (M3 hex, 3mm)
The mounting plate contains two magnets (3) that allow it to be easily mounted on a metal
surface.
The mounting plate is removable from the back of the unit after removing the screw on the
bottom (4), near the expansion connectors.
Once removed, you can screw or bolt the mounting plate through the four holes (1) and reattach
the Monitor One. This is good for rough conditions and for mounting on non-metal surfaces.
The mounting plate can be strap mounted through the two slots (2).
The magnets do not need to removed to use screw, bolt, or strap mounting.
Dimensions Metric SAE
Top, width between mounting holes 28 mm 1 3/32"
Bottom, width between mounting holes 46 mm 1 13/16"
Height between mounting holes 140 mm 5 1/2"