7300w² Monitor Instruction Manual
8 Menu Tree
Below is the menu structure of the 7300w² Monitor:
Menus in
Green
are only available in service mode or options selected in service mode.
Menus in
Blue
are only available when an expansion box is connected.
Menus in
Red
are intended for Partech Technicians only.
Main Menu
Hold Outputs
(when Service Mode is enabled)
Monitor Config
Bleeper
Backlight
Contrast
Language
Set Date/Time
Enable Service Mode
Password 00037
Disable Service Mode
Enable Factory Mode
Password ?????
Monitor Config Adv
Reset User Config
Measurement Pules
Digital Input Config
Digital Output Config
Hold Output Timeout
Enter Bootloader
Mount USB Memory
Expansion Config
Expansion Status
Add Expansion
E:# WW² EB 8A 8R
E:# Remove
E:# Modbus Addressing
E:# Comm Fail Timeout
E:# Output Comm Fail
E:# Relay Comm Fail
Sensor Config
Sensor Status
Add Sensor
S:01 Sensor Type Option
Measurement Config
Measurement Status
Add Measurement
M:01 Measurement Option (S:01)
Alarm Config
(# = refers to 1 - 8 alarms available depending on specification)
((M) = refers to Monitor, whereas (E:1) refers to Expansion Box No.1)
Alarm Status
Alarm # Config
Alarm # (M) Info
Alarm # (M) Measurement
Alarm # (M) Type
Alarm # (M) Value
Alarm # (M) Hysteresis
Alarm # (M) Fault Setup
Alarm # (M) Set Delay
Alarm # (M) Reset Delay
Alarm # (M) Test
Alarm # (M) Test Cycle
Output Config
(# = refers to 1 - 8 alarms available depending on specification)
Page 38 of 46
224081IM Issue 22 Issue Date 27/03/2018
