7300w² Monitor Instruction Manual
HOLD will hold the last good measurement if a fault occurs.
LOW will force a 4mA or 0mA output if a fault occurs.
HIGH will force a 20mA output if a fault occurs.
•
Fault Setup:
A list of possible fault conditions are displayed. If any of these Fault conditions are
detected, the analogue output will default to the setting selected in FAULT MODE. Use
or
to highlight the fault condition required, and press
to add or remove a tick. More than one
fault may be selected for an output.
•
Test:
This menu is for diagnostic use and allows the operator to test the analogue by forcing an
output. Press
or
to increase or decrease the analogue output by 0.5mA for each press.
Press
or
to exit.
•
Test Cycle:
This menu is for diagnostic use and will increase the analogue by 0.5mA every 5
seconds. Once the cycle reaches 20mA it will return back to 4mA and continue to increase
again. Used for testing and fault diagnostics. Press
or
to exit.
•
0/4mA and 20mA Offset:
Only displayed under Service Mode, the analogue outputs may be
adjusted to compensate for site conditions. See 7.1.3.
6.6.1 Output Addressing with Expansion Boxes
The standard 7300w² monitor with no Expansion Boxes connected, will only display two analogue outputs in
the “OUTPUT CONFIG” menu:
Output 1 (M) Config = Analogue output 1 within the monitor
Output 2 (M) Config = Analogue output 2 within the monitor
When an Expansion Box is connected to the 7300w² Monitor, additional configurable analogue outputs
are added to the list in the “Output Config Menu” as follows:
Output 1 (E:1) Config = Analogue output 1 within Expansion Box 1
Output 2 (E:1) Config = Analogue output 2 within Expansion Box 1
Output 3 (E:1) Config = Analogue output 3 within Expansion Box 1
Output 4 (E:1) Config = Analogue output 4 within Expansion Box 1
Output 5 (E:1) Config = Analogue output 5 within Expansion Box 1
Output 6 (E:1) Config = Analogue output 6 within Expansion Box 1
Output 7 (E:1) Config = Analogue output 7 within Expansion Box 1
Output 8 (E:1) Config = Analogue output 8 within Expansion Box 1
6.7 Information
This section provides basic information about the equipment that you have
purchased and contact details for Partech.
From the MAIN MENU, ensure INFORMATION
is highlighted (if not, press
or
to highlight the option) then press
.
6.7.1 Software Version
This function displays the installed software (firmware) version and the
monitor serial number. Please have this information available if you need to
contact Partech about this product.
6.7.2 Contact Information
This displays Partech's address, phone number and website URL.
224081IM Issue 22 Issue Date 27/03/2018
`
Page 31 of 46
MAIN MENU
Monitor Config
Expansion Config
Sensor Config
Measurement Config
Alarm Config
Output Config
Information
INFORMATION
Software Version
Contact Information
