Parsun F15BM, Service Manual

Page: 25 / 106

3. Turn the throttle stop screw clockwise or counter clockwise, until the specified idling
speed is attained.
2
1
NOTE
:
Turn clockwise to increase idling speed.
Turn counter clockwise to decrease idling speed.
If necessary, turn the idling speed screw on the carburetor clockwise
or counter clockwise, until the specified idling speed is attained.
CAUTION
:
Before adjusting the idling speed, the throttle cable
1. throttle stop screw
should be properly adjusted.
2. idling speed screw
After adjusting the idling speed, if necessary
,
you can adjust the throttle cable again
.
Start-in-gear protection
Set the shift lever in neutral, and check if the tightwire end of the arrester aligns with the marking of the
starter. If necessary, adjust the adjusting nut on the tightwire of the arrester, to make the tightwire end
align with the marking.
2
1
2
3
1.“
▋
”marking 2. t
ightwire assy, arrester
3.
adjusting nut
LOWER UNIT
Gear oil
Check gear oil level
:
Remove the oil level plug screw. If the gear oil overflows, the oil level is correct; otherwise, add gear
oil.
1
1.
Oil level plug screw
Changing gear oil
1) Hold the outboard engine in an upright position.
2) Place a container with enough capacity under the outboard engine.
19