Great Pyrenees Installation Instructions
Page 3 of 8
Mounting the Antenna
Step 1.
Clean any debris and dust off of the vehicle surface at the mounting location.
Step 2.
Feed the coaxial cables from the antenna through the hole from the outside.
Step 3.
Remove the backing from the adhesive pad on the underside of the antenna and place the antenna on the
mounting surface. Apply downward pressure on the antenna to ensure strong adhesion.
Step 4.
It is recommended to use a neutral cure silicon sealant around the base of the antenna to remove any
gaps between the antenna and the mounting surface.
Step 5.
On the inside of the vehicle, guide the flat washer, star washer (optional), and hex nut onto the cables.
Thread the washer(s) and nut onto the antenna shaft and fully tighten using a 2.25” wrench until the
antenna is pulled flat onto the mounting surface. (Figures 2 & 3)
Figure 2
Figure 3
Routing the Cables
Step 1.
Route the cables from the antenna to the router, maintaining a minimum bend radius of 0.5”. Avoid sharp
bends and run the cables adjacent to existing wiring.
Step 2.
Waterproof the RF connectors using electrical tape or heat shrink tubing, if required.