Parmco TILTA T1-6-2L, Installation And Operating Instructions Manual

Page: 6 / 12

4

The exhaust air must not be discharged into an operating smoke or exhaust
flue, or into a shaft used for ventilating rooms in which a fireplace is located.
The exhaust must not share the flue of any other appliance.

After the initial installation check that the unit has been installed level to
avoid grease collection at one end.

When the canopy is located above a gas appliance the minimum distance
from the top of the cooking surface shall be 75cm and comply with the
relevant NZ standards.

When the canopy is located above an electric cooking surface the minimum
distance from the top of the cooking surface shall be 65cm and comply with
the relevant NZ standards.

If installation instructions for the gas hob you are using specify a greater
distance please follow the hob manufacturers recommendation.

Regulations concerning the discharge of air must be adhered to. Please refer
to the relevant NZ standards.

These hoods can be re-circulated using carbon filters available from Parmco
Appliances.
WALL FIXING

Drill two holes into the wall using the dimensions set out in (Fig.1) above. Ensure
that the screws are fixed into material suitable to carry the load of this unit.

Fix the two stirrups (see Fig. 2) in position ensuring screws are tightly fixed.

Place the stirrups into the special slots in the rear of the canopy.

Loosely fix the stirrups to the canopy with the screws provided in holes A (Fig.2).

A packer may be required depending on the depth of cabinetry being used and
the depth of the fascia panel being applied to the Tilta unit.