Installation, Operating and Service Manual
For safe installation and operation of your pellet Fire, read and follow the safety instructions on pages 5 & 6 and
throughout the manual.
© 20.3.2011 Firemakers Limited Page 9
SAFETY & RATING LABEL LOCATIONS
The Rating Label is located inside the Hopper lid.
1. Each Fire has a serial number fixed to the Rating Label attached to the inside of the Hopper Lid. Record the serial
number and the Installers Registration Number on the Warranty Registration Card and post it to Parkwood Pellet Fires
within 30 days of the installation to register your warranty.
2. A label inside the Hopper Lid warns that the Fire is hot. See the safety section of this Manual for more safe operating
tips.
3. Information and warning labels are located inside the hopper lid. These labels provide information on operation and
maintenance that the operator should always follow when operating the Fire. Keep the Hopper Lid closed during
operation.
4. There are electrical warning labels inside the Fire that warn the Operator and Service Technicians, to disconnect the
Fire from the power before servicing. Also, the warning labels inform the Operator and Service Technicians that the
Fire should not be operated with the panels removed.
PELLET FIRE ASSEMBLY
REMOVING THE FIRE FROM THE PALLET
1. Remove all packaging.
2. There are 2 brackets fixing the Fire to the pallet. Use an 8mm socket to remove the brackets. These brackets
may be used as seismic restraints.
3. Clean and remove all marks from any plated Door Covers or Ash Sills before initial firing or they will
permanently mark the plated surface.
PEDESTAL HEARTH ASSEMBLY
1. Carefully place the back of the Fire on the wood pallet that the fire was supplied on.
2. Using an 8mm socket, install the four (4) bolts supplied with the Pedestal Hearth in the holes on the bottom of the
Fire Base plate. Ensure that the supplied lock washers are fitted and leave the bolt heads about 5mm out.
3. Drop the Hearth Pad Pedestal onto the bolts and lock into the correct keyhole position before tightening the bolts.
4. Taking care not to damage the rear of the Pedestal Hearth (or the floor surface), stand the Fire upright and place the
fire in position. An upside down carpet mat is helpful to shift the fire and prevent damage to floor surfaces.