Parkside PWSA 20-Li E4, Translation Of The Original Instructions

Page: 14 / 310

PWSA 20-Li E4
GB
│
IE
│
9 ■
Permissible accessories
Max. diameter Ø (mm)
Max. thickness (mm)
Thr
ead siz
e (mm)
Max speed (rpm)
Max. cir
cumfer
ential
speed (m/s)
Tool
Blade guar
d
Cutting disc 125 3 M14 ≥11000 ≥72
Two-hole mounting
spanner
With
8a
Roughing disc 125 6 M14 ≥11000 ≥72
Two-hole mounting
spanner
Without
8a
Storage and handling of the
recommended accessory tools
■ Grinding tools must be treated with care and
transported carefully.
■ Grinding tools should be stored in such a
way that they are not exposed to mechanical
damage or environmental influences (e.g.
damp).
Working procedures
NOTE
► Grinding tools should only be used for the
recommended applications. Otherwise, they
can break, be damaged or cause injuries.
Rough grinding
Never use cutting discs
for rough grinding!
■ Move the angle grinder with moderate
pressure back and forth over the workpiece.
■ For soft material, move the roughing disc
at a flat angle over the workpiece; for hard
material at a slightly steeper angle.
Abrasive cutting
Never use roughing discs
for cutting!
■ Use only tested fibre-reinforced cutting or
grinding discs
that are approved for a
peripheral speed of not less than 80 m/s.
CAUTION!
► The grinder continues running after being
turned off. Do not try to brake it by applying
lateral counterpressure.
■ Secure the workpiece. Use clamps/a vice to
hold the workpiece firmly in place. This is much
safer than simply holding it in your hand.
■ Always switch off the appliance before
putting it down and wait for the appliance to
come to a complete standstill.
■ Use the appliance only for dry cutting or
sanding.
■ The additional handle must be mounted
on the appliance for all work.
■ Materials containing asbestos may not be
processed.
Asbestos is a known carcinogen.