Parkside PTKS 2000 F4, Operating And Safety Instructions Manual

Page: 84 / 88

78
GB
The packaging is wholly composed of environmen-
tally-friendly materials that can be disposed of at
a local recycling centre.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
electrical devices.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must not be dis-
posed of together with domestic waste in compliance
with the Directive (2012/19/EU) pertaining to waste
electrical and electronic equipment (WEEE). This prod-
uct must be handed over at the intended collection point. This
can be done, for example, by returning it when purchasing a
similar product or delivering it to an authorised collection point
for the recycling of old electrical and electronic devices.
Improper handling of waste equipment may have negative
consequences for the environment and human health due to
potentially hazardous substances that are often contained in
electrical and electronic equipment. By properly disposing of
this product, you are also contributing to the effective use of
natural resources. You can obtain information on collection
points for waste equipment from your municipal administra-
tion, public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equipment or
your waste disposal company.
Do not throw primary batteries or rechargeable
batteries away with household waste
As the consumer you are required by law to bring all
batteries and rechargeable batteries, regardless wheth-
er they contain harmful substances* or not, to a collec-
tion point run by the local authority or to a retailer, so that they
can be disposed of in an environmentally friendly manner.
*labelled with:Cd = cadmium, Hg = mercury, Pb = lead
• Remove the batteries from the laser before disposing of the
product and the batteries.
19. Troubleshooting
Fault Possible cause Remedy
Saw blade is loose after
the motor is switched off Fixing nut not tight enough Tighten fixing nut, right-hand thread
Motor does not start Mains fuse blown Check mains fuse
Extension cable defective Replace the extension cable
Connection to the motor or switch not OK Have this checked by an electrician
Motor or switch faulty Have this checked by an electrician
Motor not supplying
power, fuse tripping Cross section of the extension cable insufficient See “Electrical connection”
Overload due to blunt saw blade Replacing the saw blade
Burnt areas on the
cutting surface Blunt saw blade Have an authorised sharpening service sharpen the
saw blade or replace it
Incorrect saw blade Replace saw blade
Incorrect motor
rotational direction Capacitor defective Have this checked by an electrician
Incorrect connection Have an electrician transpose the wall plug poles