Parkside PSZ 250 B2, Operation And Safety Notes, Page: 13 / 40

9 GB
Operation / Cleaning, maintenance and ordering spare parts / Disposal
Do not use cleaners or solvents; these could
affect the plastic parts of the device.
Ensure water cannot penetrate the housing.
Keep safety devices, venting slots and the motor
housing as dust and dirt free as possible.
Rub the device down with a clean cloth or
blow out with compressed air at a low pressure
setting.
Regularly clean the device with a damp cloth
and a little soft soap.
Note: We recommend cleaning the device
immediately after every use.
Periodically check the end switches on the
cable hoist are working properly (check without
load).
Test as follows: When the cable reaches the
maximum hoisting height the auto-stop
mechanism lever
5
is activated. The motor
14
must now stop. When the steel cable
6
is
unwound as far as possible, the maximum cable
length lever
4
is activated. The motor
14
must
now stop.
Periodically check the power cable
12
and the
control lead
13
.
Lubricate the steel cable
6
and pulley
15
every 200 cycles.
Every 30 cycles verify the entire steel cable
6
is in good working order in accordance with
Figure I. If damaged, it must be replaced with a
steel cable corresponding with the technical
data.
Every 1000 cycles check the screws on the
mounting bracket
1
and pulley
15
are tight.
Every 1000 cycles verify the hooks
8
/
16
and the pulley
15
are in good condition.
Verify the emergency stop switch
9
and push
buttons
10
are in good condition before every
use.
Check the brake system every 1000 cycles. If
the motor
14
emits unusual noises or is unable
to hoist the rated load, the brake system may
need to be overhauled:
- Replace damaged or worn parts and keep
the associated maintenance documentation.
- Please contact an authorised service centre
for unscheduled maintenance work.
ATTENTION!
In the event of an emergency,
immediately activate the emergency stop switch
9
to stop the cable hoist. The cable hoist cannot
be operated if the emergency stop switch has been
activated.
ATTENTION! Unplug the mains plug from the
socket before cleaning.
ATTENTION!
Verify the device is not connected
to the mains when performing care.
Below: A cycle corresponds to moving a load up
and down once.
Periodic inspection corresponds to an inspection
after 100 cycles.
The device is packaged to protect it from transport
damage. This packaging is a raw material and
therefore reusable or may be recycled. The
device and its accessories are made from various
materials, e.g. metal and plastics.
Dispose of defective components through toxic
waste disposal. Contact the speciality retailer or
your municipal government for information!
In accordance with European Directive 2012/19/EU
on waste electrical and electronic equipment and
its implementation into national legislation, worn
out power tools must be collected separately and
recycled in an environmentally friendly fashion.
Cleaning, maintenance and
ordering spare parts
Cleaning
Maintenance
Disposal
Do not dispose of power
tools in household waste!