Parkside PSZ 250 B2, Operation And Safety Notes, Page: 11 / 40

7 GB
Safety notices
specific to the device
Introduction / Important safety instructions / Safety notices specific to the device
During transport and storage the temperature may
be between -25 °C and 55 °C. The maximum
permissible temperature is 70 °C.
Please read all safety informat-
ion and instructions. Failure to observe the safety
information and instructions can result in electric
shock, fire and / or serious injury. Keep all safety
instructions and directions for future use!
Important safety
instructions
Always verify the mains voltage matches the
voltage on the nameplate. If the mains voltage
is not suitable, abnormal device operation and
personal injury may result.
The power supply must have earthing and be
protected by an earth leakage circuit breaker.
Hoisting loads exceeding the rated load is
prohibited.
Only use the device for the intended purpose.
Never hoist persons with the cable hoist.
Do not unplug from the socket by the cable.
Keep the cable away from heat, oil, and sharp
edges.
Never attempt to hoist fixed or blocked loads.
Remove the mains plug from the socket after
every use.
Keep children and other unauthorised persons
away from the device.
Pulling loads sideways or from one side is proh-
ibited. Prevent the load from swinging.
Ensure the hook
8
moves in the direction
shown on the push button
10
.
Regularly check the cable hoist for damage.
The push button
10
must be in good condition.
Always have repairs and maintenance
performed by an electrician at an authorised
specialist workshop. repairs must be performed
by an electrician to prevent operator accidents.
Avoid rapid start-up and powering off (inching
mode).
Always be attentive whilst operating the cable
hoist.
Never stand or work below the hoisted load.
Hoisting stuck or jammed loads is prohibited.
Always pull the mains plug before executing
settings on the device.
The cable hoist is not suitable for transporting
hot and / or molten materials; the cable hoist is
further not suitable for use in low temperatures
or in environments with severe weather (see
Technical Data).
The service life of the cable hoist is approx.
8000 cycles (excl. wear parts). Once the hoist
has reached 8000 cycles all mechanical parts
must be inspected and overhauled.
Read and understand the operating instructions
before using the cable hoist.
Ensure the operator is familiar with the
functionality of the device and how it should be
operated.
The user must always operate the device in
accordance with the operating instructions.
The hoist is not intended for continuous
operation.
The duty type is:
Intermittent duty without the effect of starting.
After opening the packaging, please inspect the
device, the steel cable, the hooks, the maximum
cable length lever and the auto-stop mechanism
lever for transport damage.
The user must hoist the load from the ground at
the slowest possible speed. The cable must be
tightened when the load is being hoisted.
The electric cable hoist is not equipped with
a rated power limit. Therefore do not continue
attempting to hoist the load if the overheat
protection limits operation. In this event the load
exceeds the rated power of the cable hoist.
Do not leave suspended loads unattended
without taking the appropriate safety
precautions.
Secure the device with a 10 A fuse or a 10 A
earth leakage circuit breaker to protect the
electric circuit.
Do not use the lever
4
/
5
as a routine stop.
These are only intended as emergency stopping
devices.