16
PSTK 800 A1
GB
Initial operation
Fitting/changing the saw blade
Always remove the plug from the power socket
before working on the appliance.
♦
Remove the pivoting guard .
♦
Turn the quick-release chuck and hold it in
this position.
♦
Press the required saw blade into the quick-
release chuck as far as the limit stop.
♦
Release the quick-release chuck – it must
return to its initial position. The saw blade is
now locked.
■
WARNING! The saw blade teeth must point
forwards at this point (see foldout page)!
♦
Replace the pivoting guard back onto the
device.
Fitting the guide fence
The guide fence can be fixed on the left or right
of the appliance.
♦
Undo both the clamping screws on the insertion
openings .
♦
Push the guide fence into the insertion open-
ings .
♦
Retighten the two clamping screws.
Connecting the sawdust extraction
appliance
♦
Push the reducer into the extraction connector
until it is secured.
♦
Attach an approved dust and sawdust extractor
to the reducer or extraction connector
directly.
Fitting the sliding shoe
When working on sensitive surfaces, you can fit
the sliding shoe on the baseplate to avoid
scratching the surface.
♦
Mount the sliding shoe onto the baseplate
and press it up at the back until it clicks into
place on the baseplate .
♦
To remove the sliding shoe , unfasten it at
the rear of the baseplate and slide it off
forwards.
Operation
Setting the cutting angle
♦
Push the clamping lever forward and pull the
baseplate to the rear.
♦
Adjust the cutting angle to 0°/15°/30°/45°
with the aid of the markings on the baseplate .
Push the baseplate to the front so that the
locking pin engages in the toothing .
♦
Push the clamping lever backwards.
NOTE
►
With a cutting angle of 30 ° / 45 °, the pivoting
guard must be removed beforehand! If the
baseplate cannot be locked well by clamping
lever , remove the extraction connector ,
then tighten the clamping screw
with hex key.
Setting the stroke rate
♦
Use the stroke rate preselection adjusting
wheel to set the required stroke rate.
Setting the pendulum stroke
♦
You can use the pendulum stroke switch to set
the pendulum movement of the saw blade .
You can achieve fine, clean cut edges without
pendulum movement (setting “0”). Switch the
pendulum movement off when working on thin
workpieces. You can achieve an increasingly
fast workrate with activated pendulum stroke
(settings 1–3).
Switching on/off
Switching the appliance on:
Slide the ON/OFF switch forward to the position “I”.
Switching the appliance off:
Slide the ON/OFF switch backward to the
position “0”.
