![background image](http://html1.mh-extra.com/html/parkside/pmnf-1350-c3/pmnf-1350-c3_original-instructions-manual_4156947015.webp)
1 5
NI
IE
GB
Handling
Using a line locator, check
the walls for hidden electrici-
ty cabling and gas and water
pipes before working with
the wall chaser.
1. Switch on the wall chaser, positi-
on the start roller (9) against the
wall while the cutting disks are
rotating.
2. Bring the cutting disks into con-
tact with the wall.
3. The cutting direction should al-
ways be opposite to the disks’
rotational direction. Check the
marking (14). Otherwise, the
wall chaser can be pushed
outside the cutting area in an
uncontrolled manner.
4. Once you reach the end of the
groove, remove the device from
the groove before switching it
off.
5. Chip out the resulting ridge bet-
ween the two grooves using the
hand chisel (12).
Cleaning and servicing
Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this in-
struction guide performed by
a professional. Only use ori-
ginal parts. Allow the device
to cool off before any mainte-
nance or cleaning is underta-
ken. There is a risk of burning!
Always check the device before using it for
obvious deficiencies such as loose, worn
or damaged parts, correct the positioning
of screws or other parts. Examine the
grinding disc in particular. Exchange the
damaged parts.
If the replacement of the supply cord is
necessary, this has to be done by the ma-
nufacturer or his agent in order to avoid a
safety hazard.
Cleaning
Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
Storage
• Store the appliance in a dry place well
out of reach of children.
• Grinding discs must be dry and stored
upright and should never be stacked.
Waste disposal
and environmental
protection
Be environmentally friendly. Return the tool,
accessories and packaging to a recycling
centre when you have finished with them.
Summary of Contents for PMNF 1350 C3
